vacuum annealing
英 [ˈvækjuːm əˈniːlɪŋ]
美 [ˈvækjuːm əˈniːlɪŋ]
网络 真空退火
双语例句
- Influence of vacuum annealing treatment on mechanical and tribological property of chromium-doped graphite-like carbon coatings
真空退火处理对掺Cr类石墨碳膜力学和摩擦学性能的影响 - Design of PLC control system of vacuum annealing furnace for quartz crystal
基于PLC的石英晶体真空退火炉控制系统设计 - Development of a vacuum annealing furnace for aluminium foil in protective atmosphere;
该模拟实验机可模拟带张力试样在不同保护气氛下的退火生产过程。 - The development of computer control system of large-sized vacuum annealing furnace for the tube
大型管材真空退火炉计算机监控系统研制测 - A new soft magnetic alloy with high frequency was prepared by atomized powder, molding and vacuum annealing technology.
鉴于兆频带近场电磁干扰抑制材料需求的增加，采用气雾化制粉、粉末扁平化、绝缘压结、真空退火工艺制备出具有高频宽带分布磁导率特性的新型软磁合金复合材料。 - We also analyzed the effects of processing parameters, such as the composition of magnetic layer and under layer, the thickness of seed layer and the vacuum annealing, on the properties and microstructure of thin films.
同时，也详细分析了磁性层和底层组分、籽晶层厚度以及真空退火对磁记录介质磁性能和微结构的影响。 - Study on the Microstructure of VO_x Thin Films Prepared by Vacuum Annealing Method
真空退火法制备的VOx薄膜的微观结构研究 - The effect of vacuum annealing on the phase and morphology of the vo_x thin films
真空退火对VOx薄膜相结构及表面形貌的影响 - After vacuum annealing, the FeAl ( B_2) intermetallic phase forms and dominates in the powder microstructure.
经进一步真空热处理后，粉末物相转变为以FeAl（B2）为主的金属间化合物。 - Modeling and optimization for vacuum annealing furnace
真空退火炉的建模与优化 - Heat design of large high vacuum annealing furnace
大型高真空退火炉的热设计 - The accurate control of the work pieces temperature in vacuum annealing furnace is a typical nonlinear large time delay and cross coupling complicated problem.
而在真空退火的生产过程中，退火工件温度的精确控制是一个典型的非线性、大时滞、强耦合的复杂控制问题。 - The optical and electrical properties of the films will be improved by in-line vacuum annealing and SiO_2 isolate layer between substrate and ATO layer which can improve annealing temperature of the films and lengthen annealing time of the films.
薄膜的在线真空退火工艺和SiO2隔离层都能提高薄膜的退火温度和延长薄膜的退火时间，能够改善薄膜的光电性能。 - Modeling and Control for Vacuum Annealing Furnace Based on Intelligent Method
基于智能方法的真空退火炉建模与控制 - The effect of vacuum annealing was also discussed.
也讨论了真空退火的影响。 - The optimal temperature of vacuum annealing of deformed alloys, and the char-acteristics and mechanism of deformation of biphase W alloys have been discussed in this paper as well.
本文还讨论了变形合金在真空下，最佳调质退火温度和两相钨合金的形变特点、变形机制等。 - The accurate control of the temperature of work pieces is a nonlinear uncertain complicated control problem in vacuum annealing furnace.
真空退火炉中工件温度的精确控制是一个具有非线性和不确定性的复杂控制问题。 - Research and application of intelligent variable structure control method for vacuum annealing furnace
真空退火炉智能变结构控制方法的研究与应用 - A study is carried out to determine the radial temperature difference in an existing pit type vacuum annealing furnace and improve the temperature uniformity in it.
针对径向温差导致同炉处理的同类产品力学性能的离散和差异，利用现有的装备条件对井式真空退火炉胆内径向温度梯度进行测定，并在提高径向均温性方面进行探索和研究。 - Mechanism Analyses and Optimization of Vacuum Annealing Furnace Model
真空退火炉模型的机理分析与优化 - Vacuum Annealing of LiF and CaF_2 Thin Films
真空退火对LiF和CaF2薄膜结晶性能的影响 - The selection of pickling solution, time and temperature are expatiated, and the control of heat preservation, heating and cooling speed for vacuum annealing are studied.
阐述了抛光前处理时酸洗液的选择、酸洗温度和时间的控制，以及真空退火时升温速度、冷却速度和保温时间的控制； - The dependence of magnetoresistance of CoCu granular alloy film upon vacuum annealing temperature, applied magnetic field, and alloy composition was studied.
研究了CoCu合金颗粒膜的磁电阻随真空退火温度、外磁场以及组元成分而变化的规律。 - Co particles with fcc structure are precipitated from CoCu granular film after vacuum annealing.
经真空退火后，CoCu颗粒膜中析出的Co颗粒呈面心立方结构。 - SiC nanocrystal ( nc-SiC) films were prepared on Si ( 111) substrates by RF magnetron sputtering and then annealed at 800 ℃, 1 000 ℃ and 1 200 ℃ for 30 min in a vacuum annealing system.
用射频磁控溅射及后退火（800℃、1000℃和1200℃）方法，在Si（111）衬底上制备出了SiC纳米晶（ncSiC）薄膜。 - The fine-grain strengthening mechanism enhanced the bending strength and toughness of Mo slab, and improved mechanical properties after the high-temperature vacuum annealing.
由于细晶强化机制，提高了钼板坯的抗弯强度和韧性，以及La-Mo合金板坯高温真空退火后的力学性能。 - Vacuum annealing can repair the damage of crystal lattice, and this result in further reduction of film square resistance.
真空退火对晶格损伤有修复作用，同时导致薄膜方块电阻进一步降低。 - The effect of the different annealing methods on the magnetic properties of DyCo/ Cr thin film was researched. We have found that vacuum annealing method is helpful to increase the coercivity of DyCo/ Cr thin film.
研究了不同退火方式对DyCo/Cr薄膜磁性能的影响，发现真空退火有利于提高薄膜矫顽力。 - The total deformation is up to 80% or more before rolling and passing in vacuum annealing, the samples can be obtained.
实验运用真空退火炉，通过采用轧前和道次退火的方法制备了总变形量达到了80%以上的轧样。 - The hydrophilia and surface adsorption states of film modified by ion implantation were mediated by effect of the ion implantation and vacuum annealing collectively and present diversity. 2.
离子改性薄膜的亲水性和表面吸附态同时受到离子注入、退火和氧化钛薄膜的共同影响而表现出多样性变化。